Turbine and Panel
Live
Technologies

Emulsion buffer layer mitigates screen printing degradation in copper-plated HJT solar cells

Researchers at LONGi Green Energy Technology have developed an emulsion buffer layer that prevents screen mesh contact, limiting efficiency degradation in copper-plated heterojunction solar cells during manufacturing.

Researchers at LONGi Green Energy Technology have developed an emulsion buffer layer that prevents screen mesh contact...

A team at LONGi Green Energy Technology has developed an emulsion buffer layer to combat screen printing-induced degradation in copper-plated HJT solar cells. The innovation addresses a critical manufacturing challenge for this cost-effective alternative to silver-based metallization, improving device reliability without sacrificing performance.

Led by corresponding author Lang Zhou, the team designed the layer to stop direct screen mesh contact with the wafer. This simple screen design change reduces cumulative mechanical damage to sensitive passivation layers. The findings demonstrate that a simple screen design change can significantly improve manufacturing reliability for copper-plated HJT cells.

Optimal emulsion coverage ratio identified

The study evaluated six different emulsion patterns to find the best balance between protection and function. Coverage ratios tested ranged from 2.9% to 16.6%.

An emulsion coverage ratio of 4.7% provided the best balance between mechanical protection and ink distribution uniformity. This specific configuration limited minority carrier lifetime degradation to just 0.41% after 10,000 printing cycles while maintaining good coating uniformity.

Mechanism of degradation confirmed

Screen printing causes degradation in copper-plated silicon heterojunction solar cells by damaging passivating contact structures. This increases recombination losses and reduces conversion efficiency.

Three-dimensional confocal microscopy identified progressive wear of screen mesh knuckles as the main cause. The wear increases mechanical stress on passivation layers, leading directly to higher recombination losses. Scanning electron microscopy revealed no visible surface scratches, but photoluminescence measurements confirmed increased recombination losses at the amorphous silicon/crystalline silicon interface.

Performance impact quantified

Screen printing-induced degradation has a measurable impact on cell performance over time. In commercial production testing over 15,000 consecutive printing cycles, conversion efficiency declined from 26.2% to 25.7%.

The efficiency loss was primarily driven by reductions in open-circuit voltage and fill factor. Short-circuit current density and electrical resistance remained largely unaffected.

Minority carrier lifetime degradation increased substantially over the same period.

MetricNew ScreenAfter 15,000 Cycles
Conversion Efficiency26.2%25.7%
Minority Carrier Lifetime Degradation0.61%11.0%

Context from industry benchmarks

The research tackles a key hurdle for copper-plated HJT cells, which are seen as a cost-effective alternative to silver-based metallization. The 15,000 consecutive printing cycles tested represent standard industry durability benchmarks.

Recent industry work shows the efficiency potential of copper-based approaches. In April 2026, researchers at China’s Nankai University developed a silver-free HJT solar cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating.

Other groups have also posted strong results with copper metallization.

Research InstitutionCell ConfigurationEfficiency
Forschungszentrum Jülich (Germany)Fully copper-metallized HJT23.08%
Not SpecifiedSilver-copper paste front, silver contacts rear23.95%

Lang Zhou highlighted the unique challenge, stating: "The screen-printing process for photoresist application in HJT cells differs fundamentally from conventional screen printing of silver paste." The findings were published in the journal Solar Energy under the title 'Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells'.

Related coverage

More from Technologies